Roller Coaster Car

You are going to build an arrow car today.  Build the Arrow Car.  Build the Arrow Car.

Another Car

  1. Start Blender.

  2. Delete the cube.

  3. Click >Add  >Mesh  >Plane.

  4. Select the front vertices. 

  5. Go to side view.

  6. Press the E KEY for extrude.

  7. Move your mouse up to extrude the front of the car up. 

  8. Go to top view.

  9. Select the vertices in the back. 

  10. Go to side view.

  11. Press the E KEY for extrude.

  12. Move your mouse up to extrude the back of the car.  Make the back higher than the front. 

  13. Select the four vertices of one side of the car.  You will need to rotate your view to do this. 

  14. Press the F KEY. 

  15. Go to side view.   

  16. Press the K KEY.

  17. Click Loop Cut. 

  18. Move your mouse up to the side of the car until you get a pink line. 

  19. Left Click.

  20. Move your mouse to the left to place the line towards the back of the roller coaster car. 

  21. Press the A KEY to select all.

  22. Press the K KEY.

  23. Click Loop Cut. 

  24. Move your mouse up to the side of the car until you get a pink line. 

  25. Left click.

  26. Move your mouse to the right and click. 

  27. Select the four new vertices that you created. 

  28. Go to top view.

  29. Press the E KEY for extrude.

  30. Move your mouse in a little and click. 

  31. Do something similar on the other side.

  32. Get ready to add the wheels.  Your wheels can be found by click  >add  >mesh  >Torus.

 

The Arrow Car

  1. Start Blender.

  2. Delete the cube.

  3. Click >Add  >Mesh  >Plane.

  4. With the plane selected press the K KEY.

  5. Click Midpoints.

  6. Drag your knife from the top to the bottom of the plane. 

  7. Press Enter

  8. Select the vertices at the top. 

  9. Press Alt M.  Click At Center. 

  10. Press the A KEY to deselect.

  11. Select the 3 vertices at the bottom. 

  12. Click Subdivide.

  13. Select the 3 vertices in the middle now. 

  14. Press the E KEY.

  15. Move your mouse down. 

  16. Press the S KEY and move the points away from each other a little bit. 

  17. Go to side view.

  18. Press the E KEY for extrude.

  19. Move your mouse down a little bit and click.

  20. Here is your arrow. 

  21. Give it some color so it is easy to see. 

  22. Go into object mode.

  23. Press the S KEY and make your arrow smaller. 

  24. Locate Center New and click it.